Wall Mount for TP-Link Deco M5 Whole Home Mesh WiFi System, Sturdy Bracket Holder Designed for TP-Link WiFi Router Excellent Cord Management without Messy Wires or Screws Fit UK Plug

This arrived in a small cardboard box without instructions. I took the approach that I didn't need a manual so I set about trying to install my deco unit into the holder. That didn't work! A quick look at the photos of the product on Amazon and all became clear! The plug must be inserted snugly into the rubber section exactly as illustrated to ensure it fits. I quite appreciate the snug fit because it supports the whole unit from the plug and the socket. The cable can then be wound around the reverse-side of the holder following guides. The other important point to note is that the power socket on the deco unit should point through a rectangular hole on the side of the holder. The contoured circular case of the deco means that it will be held most effectively if you orient it with the power socket in that position. Once that was figured out, simply plug it in and presto! An excellent product that does exactly what it says.

This is the exact product I need to mount the Deco M5. However I was almost put off to buy it by the some of the reviews which claimed the product will not fit UK power plug. I took a chance. In fact it does fit the UK plug perfectly!!! Now my Deco M5s sit on the power socket nicely and it is vert tidy. I am very pleased with the product.

This bracket helps to keep the TP Link mesh device nicely out of the way and is a neat alternative. Our M5 units came with UK plugs and flat power cables. The plugs fitted into the rubber holder superbly but keeping the cable wound into the back of the bracket was difficult and after the fifth or sixth attempt I resorted to some tape to keep it in place. Because this bracket is being used on the main one near the Virgin router it also has two ethernet cables going into it which actually works very well. I only bought one Stanstar bracket even though we have four M5 mesh units and I will no go back and buy three more brackets because they work and now that I know to use tape to hold the power cables they work well.

I needed somewhere to store the Deco on the landing without it getting in the way. This was a perfect solution for me. I had a spare double socket low down on the wall which is where the Deco is now installed (in the left-hand socket). It is neat and out of the way and so far, no one has caught it yet. It projects 7cm from the face of the socket so I will probably take it out if I am moving anything large around just in case. Although it is low down, the coverage upstairs still seems to be good.

Fit the TP link deco fine The place to put the cables isn’t great but it works. The plug holder is secure and you can mount the plug left or right if needed. Keeps the Wi-Fi box up on the wall and the cable all wrapped up.

I don't usually write reviews but this product is just perfect, mounts the AP away from the wall to allow for heat dissipation and it keeps the dreaded cables from showing..... Wife now happy that wires are not dangling everywhere so.....Happy Wife Happy Life

Nice compact wall mount bracket for my TP-Link Deco M5. I like the design, it fits well, has built-in cable management, no screws required. It sticks out a little from an angle, however much better than having my Deco sitting on the floor. I like the fact that I still have access to my second power outlet. Overall, it’s a good fit for my Deco M5, I found the plug fitting a bit fiddly, if you angle the plug downwards when installing into the bracket, it makes it easier. The cord management is not the best, the reel doesn’t hold the cable that well, I just stuck a bit of blue-tac to keep it in. Once fitted, it hides the cable and looks neat and tidy.

The plugs are an extremely tight fit into the holder and care needs to be taken to ensure you don't damage the cable where it enters the plug. Did wonder if the holder and the units were entirely compatible!

Se adpatan perfecto

Arrived in 4 days to the UAE from the US. Does the job in providing a neat finish. I did struggle to wind the cables into the back, not sure if it's been designed for thicker cables... My mesh routers came with flat power cables, therefore had to wrap it twice in each channel to ensure a snug fit

Using as adveMesh rtised works very well

I ended up moving things around and no longer had a place to place one of my Deco M5's. I looked at some generic shelves, but everything looked kind of cheap. I then found the Stanstar wall mount. It works exactly as described. The Deco snaps inside, the power cord wraps around the underside then the plug goes through an opening and the whole thing plugs into the wall. Cutouts are provided for the ethernet ports. It's sturdy, no drilling or tape is required, and it only sticks out from the wall as thick as the Deco is. I would definitely buy more if I have to move the other 2 Decos.

I've considered purchasing these for a long time, but thought they were too pricey. I finally decided to purchase and can't believe I waited. They take a somewhat unsightly tech tool and tuck it away in an organized and minimalist manner. The only issue is they arrived with absolutely no information. I try to use Amazon day for delivery and that means that sometimes items arrive more than a week after I order them. That was the case with this item and I thought they might be related to one of my other items delivered on the same day. There was no product name anywhere and no installation instructions. I had to go to my Amazon orders to figure out what they were! Installation wasn't that tough, but it took a couple of tries to get the plug and the cords right. I suspect some folks might have trouble figuring it out. I can't believe the manufacturer/distributer doesn't include a small card with the product name and two or three installation instructions. I didn't reflect this issue in the overall rating because it is not a product issue.