Ultra Low Profile Scope Level

I've used a lot of scope levels and these are the worst. The first time I went to tighten it onto a scope it started rounding out the threads that hold it tight. I didn't come close to over tightening it! Don't waste your money. Even the $10 Chinese aluminum scope levels are way better.I've used a lot of other products from MK machining. Basically everything they machine out of aluminum is great. But anything 3d printed in polymer has been junk. MK machining, please stop wasting our time with this crap that doesn't work.

I contemplated sending it back and paying 15$ more on a vortex, because it took me over a half hour trying to get the damn bolt to thread into the insert. I'm surprised it didn't snap: I was trying to squeeze it together so hard to get the bolt started. Once i finally did get it started, it felt tight after one or two revolutions and i needed to move it since it wasn't level with the reticles so i backed it off and it came undone again.FML! By this time i knew where to put all my force at to get it started again. Shouldn't be that difficult. I think the product will work good, since the bubble is protected and shouldn't fall out like one of the really cheap one's ive bought in the past.

Not a bad product, although I cannot reccomend it due to the install process. Very difficult to actually make level with the way it screws onto the optic tube.