LuxorTub Cart - Black

Light weight and rigid I use this as a mobile desktop for my laptop and hand tools in my job.

Pour l'atelier, très pratique pour activité temporaire et facile à déplacer!

I purchased this to hold my 85 lbs VP215 and bags (20 lbs and 45 lbs) and parts (5 lbs). Wanted the shelf top to hold the machine and the tub middle and bottom to hold bags and associated parts for the machine. I wanted the cart in case I need to move it from its intended location.Loaded per above the cart rolls easily over carpet and hard flooring. It does not feel top heavy or flimsy. The casters move a bit when locked, but that is the nature of the casters. It took me about 10 minutes to assemble with a 16 oz rubber mallet. I was wailing on it pretty hard to get the tubes to set on the tapered posts on the shelves. I was afraid I would break the tubes from hitting them so hard, but they did not break. Try to hit the tubes square as possible and progress corner to corner around until properly seated. Some mold flashing broke away from the tubes or posts. I assembled it on carpet, may be a bit easier if done on a hard surface that is not padded. Take care to support under the posts to prevent damage. The casters snapped in without needing the mallet. The snap ring on one of the casters was out of place and made it hard to insert. I snapped it into alignment and it went in fine. I wrapped the cord around the handle/cord wrap. Works exactly as I desire it to work. Instructions were simple pictorial with minimal English (written by someone that knows English, not copied from Google translate from Chinese) instructions.This is a medium duty cart made of foamed structural plastic. I'm not sure what the tubes are made from, but they are substantial. It is much more solid feeling than the metal post and wedge carts listed as microwave carts. Overall, I'm glad I bought it and recommend it. Yes, you will need a rubber mallet to assemble.UPDATE May 3, 2019: The top is not holding up as well to the weight of the VP215 as I had hoped. It noticeably deforms from the 85 lbs weight at the 4 rubber feet. I am not afraid of catastrophic breakage, but may take a permanent set from the weight and crack the top after several years. The top shelf is very near its rated capacity with 4 point loads. The rating is for evenly distributed loads. Not disappointed, but am looking for a solution to more evenly distribute the weight.

Sehr gutes Produkt, passt für mich wie vorgesehen, wirkt sehr stabil und hält locker einen voll befüllten kleinen Kühlschrank aus - absolute Kaufempfehlung, danke, gern wieder!

Just what I needed for my classroom. Sturdy, light weight, portable. Note: I didn't order the optional power strip (not even sure if it was available) but I would recommend getting it to cut down on extra cords hanging around.

I bought this for Grandson's 3D printer, just a perfect match! Very few pieces to assemble, but the wheels need to be pressure fitted in with a rubber mallet. The vertical tubes were round, where the instructions showed square, that was not really an issue, what was an issue is that it took quite a bit of convincing with the rubber mallet to get the tubes fully seated. Once assembled, it's a great unit! Would buy again!