Motorcraft TPMS19 Transmitter

Funktioniert nicht mit Ford Mustang Modellen ab Bj 2013 - xxxx. War nach langem ausprobieren direkt zum Ford Händler gefahren. Die konnten weder diesen Sender noch die Tpms Sensoren anlernen. Folgende wurden mit dem Produkt empfohlen: 4 Reifendrucksensoren RDKS IM TPMS für Ford Galaxy Mustang S-MAX Reifendruckkontrollsystem 6547-B https://www.amazon.de/dp/B01N74RXDR/ref=cm_sw_r_cp_apa_i_uBc3Bb3RTDQFS Trotz Kompatibilität nicht möglich anzulernen :( Sparrt euch die Zeit. Benutzt nur die mitgelieferten Sensoren von der original Maschine oder fahrt im Winter mit einem nervigen Symbol.

I did not receive this item for a day, so I noticed the TPMS light went out all by itself after going for a drive the day after changing back to the summer tires from winter tires. Tried the item anyway, since I assume that the car recognised the original tires but would not know they are now rotated. For our car, which has a pushbutton start, the method is as follows. Push and release the brake. Turn the car on with a two second push of the start button and turn off the car with a quick push twice.. Turn on the car a third time with a two second push. Push and release the brake. Turn the car off with a quick push. Turn the car on with a two second push of the start button and turn off the car with a quick push two more times. Turn on the car a sixth time with a two second push. The horn should honk to indicate train mode and the dash will tell you what tire to do (left front first). Hold this handy gadget against the wheel at the valve stem and push the button. The light on the tool will illuminate and a few seconds later the horn honks. Proceed following the order displayed on the dash until all four tires are done (right front, right rear, left rear). I think the car then turned itself off, but I could have been mistaken. Note this item works without needing to open the original packaging, so if it does not work it would be easy to return. This item came in an sealed Motocraft plastic bag. I tossed it in the back with the tire repair kit. I did this with the winter tires hanging right above the car, so it didn't seem to care much about other nearby sensors.

لاتعليق

It worked on a 2017 Mustang & a 2014 Focus

Bought this product as I installed new TPMS sensors in my Focus RS (2016-2018 years). Worked like a charm. PLEASE UNDERSTAND there are in fact TWO different ways to learn/re-learn your tire pressures. If you just installed new ones and need to sync them to the car for the first time, here is the process: (DO NOT DEPRESS THE CLUTCH TO START CAR!) -Turn ignition to the OFF position -Press and release brake pedal once -Quickly turn the ignition from OFF to RUN/ACC (engine OFF) three times, stop in RUN position -Press and release brake pedal once -Turn ignition OFF -Quickly turn the ignition from OFF to RUN/ACC (engine OFF) three times, stop in RUN position NOTE: All the steps for this process must be performed within 10 seconds. A single horn chirp will indicate the relearn mode is active. After you hear the chirp, the dash should read something like “Tire pressure training mode” and will prompt you to start at the left front tire (LF), then the RF, then the RR, and lastly the LR. Hold the clicker aimed directly at the tire stem as close as possible (or next to the tire stem where the tire meets the rim) as that is where the sensor is located. After each tire is “learned”, it will chirp one time and tell you to move to the next tire which again, starts at driver’s side front tire and goes clockwise around the car. The second possible way to RE-LEARN sensors if you have the same ones installed but changed tires or did a tire rotation is: (DO NOT DEPRESS THE CLUTCH TO START CAR!) -Turn ignition to RUN/ACC position (engine OFF) -Quickly press the hazard button 6 times -The horn will chirp one time and the process will be exactly the same by going to LF tire and worming clockwise with the clicker. This is also the GENUINE MOTORCRAFT CLICKER, not some garbage one. Worked great for me!