10 Pcs Barbed Tee

I cannot believe that some of the big sprinkler supply companies do not make these. These worked great for drip irrigation system so you have a main trunk line and 1 of put out quarter inch distribution lines. since they have screw on collars that secure the connections to the main line, they really do not leak and they are easy to assemble. This is my second purchase of these. I will keep buying them when I need them

They work great, don't leak, and go on pretty easy but extremely tightly. I have them running now at multiple locations and they are working perfectly. For my hydroponics system I have a 1/4 hose splitting to two more 1/4 hoses, and have had no problems. Highly recommend!

Standard drip tubing (in my case, Raindrip) fits on these tees. The 1/2" sides work well. The 1/4" barb is a VERY tight fit and we had to carefully and quickly heat the tubing with a propane torch to get it on reliably, but it can be done. There aren't a lot of reducing tees for drip tubing around and these do work.

I've seen many comments stating that the FULAIERGD 10 Pcs Barbed Tee 1/2 inch Tubing (1/2" ID x0.6-0.63" OD) is not standard size, but when I bought this package, I also purchased the RainDrip 052020P Drip Watering Hose , Black Polyurethane 1/2 inch x 200 Ft from Amazon. These two items fit perfectly together, and I also purchased the MIXC 1/4 inch Blank Distribution Tubing Drip Irrigation Hose, 50ft Roll and the Orbit DripMaster 65201 Flag Dripper, 4-Gallon Per Hour, 10-Pack , Green from Amazon and set up my Oak Tree Irrigation System in not time, and without any problems. I'll certainly purchase these items again in the future if I decide to add more trees to our property.

The fitting was used in an irrigation system. The 1/2 inch hose was attached to both ends and a 1/4 inch hose connected to the small center barb. Installation was petty easy if you heated the hoses correctly. The screw downs made the end connections very secure and waterproof.

Easy to use

Only worked on new black 1/2 inch pipe. The green cap took forever to get on. And would not go on 1/2 brown drip. So had to put connector to brown drip and new black and the same at the other end. Putting a 1/4 drip line was also very hard. The barbed connector was to large. 1/4 inch tubing only might might work. Since I wanted a shut off. Had to put a short piece, on/off valve then the 1/4 drip line.

Misleading thought it would fit, but the green part didn’t want to go in over the tube. Who measures the exterior dimensions of their tubing? Showing it fits for 1/2 inch without more obvious warnings makes for disappointment. However, using a handheld torch and heating the tubing ends a bit allowed the green cap to fit with a bit of force.

Wrong size, far too small for 1/2 inch poly pipe. Maybe it's metric? Wasted my time and money

Great product and arrived on time thank you so much