Soda can lids

Game changer- ever want to take an open 12 oz pop can with you to go or in the car but worried about risk of spills or contaminants getting into your soda ( like bees in the summer)? . Here’s a handy solution to all those worries and what I would expect would keep in carbonations and keep out fridge odors for this if you are one that just never drinks a whole 12 oz at one sitting. Mine actually were applied for the first time today and the score is me : 1 and spills : 0 even with the help of the cat. I’m super thrilled with these. Easy in and off and drinks like a 20 oz bottle. Love the resealable lid. I would wash or wipe off the can too ( that’s just me) since the liquid is in contact with the full top of the can while drinking. Multipack means sharing with my adult daughter and two older ‘mother/mother-in-law folks as they are always putting 1/2 finished pop into the fridge only to pour it out the next day since it lost carb/tastes like fridge. Or they buy the more expensive “ mini cans”. I think this will fit their needs perfectly. This top could function for a toddler allowing a careful sip out of a flavored water without it going everywhere. My first use was flavored seltzer and top fit that alt beverage type ( non cola) perfectly. I’d think these would be good when doing mixers where multiple open cans for use with mixing. Color coded so no more deciding what’s yours and praying you’re not sharing with the person with sniffles. This was a BuzzFeed shopping recommendation on some compiled list or another and absolute “ WIN” in my book. The fact that you get (6) in the package made the per item cost a bit more affordable. Not sure about “ dishwasher friendly status” - I’m afraid they’d melt like the budget “solo” cups I tried sending through. But that’s another review…….

I would recommend you clean or wipe off the top of the can before you push on the cover or you will be drinking whatever might be on top of can. Yuk They do not "click" on can and hold as tightly as my old set purchased years ago but they work just fine. They slip on and off without issue. They seal tightly and do not leak. I would expect them to pop off if your can fell off the table to the floor but held up well when I simply knocked can over. Did not leak and it took 12 times before top finally popped off when I tested mine. It will work just fine for drinking a cold pop around the house or in the outdoors but do not expect them to stay sealed if you are rough with the can. Also, once you open a can of pop the clock is ticking on how long it will stay fizzy no matter what you do. I have washed them in dishwasher on top shelf without issue. I see main advantage using these covers is keeping bugs out and reducing accidental spills if can is knocked over. Only marginally helps retain fizz.

I love these they do pop off pretty often if you don’t like push push them on and iv had trouble getting them on monster cans but for cans of soda that work wonders

Does what its designed to do Just be careful with carbonated drinks It can pop it off

For years, I've been using a metal coaster to keep bugs out of my soda. I was hoping these lids could also keep the fizz in. The first one I tried, didn't snap into place at all. The rest went on perfectly. They don't leak. They do not, however, trap carbonation. My coaster does a better job. If someone drinks their soda quickly, it would work fine. I nurse my drinks, though. I tend to rotate bottles from the fridge throughout the day or I waste half a can as it gets flat. I could see these lids being great for family BBQ's and picnics though.

These are perfect. I wish I’d found them sooner. I’m the type of person that can’t drink a whole can of Coke. This now allows me to keep it and sip on it all day and it keeps it carbonation as if it were a bottle. It will save me quite a lot of money now I can buy cans.

Trash. Pure trash. First the good: it snaps on the can, and the top screws on and off nicely. That's it. I wouldn't even say it snaps on the can well, to be honest. It barely holds on there. As for keeping anything fresh? HA! Nothing about this keeps the beverage fresh. The beverage goes flat in the fridge. Perhaps if you aren't using it with something carbonated and you simply want to convert from can to bottle for drinking, and you aren't giving this to a child (I'd never trust the thing to stay on and expect a giant mess), maybe it's OK? A waste of money, if you ask me. Don't do it!

we purchased about 80% of our stuff on Amazon cheap things expensive things all kinds of things by far. This is my favorite purchase in years. It is not meant to be held upside down. It holds tightly to the can once you release a little bit of carbonation I am a truck driver and I use these every day. Thank you.

These are the Best with my kids

Very easy to use and clean. Easy to install and remove. Keeps drinks fresh.

Ok, a lo mejor pensarán que me estoy llenando de plásticos de un solo uso, pero, al ser consumidor habitual de bebidas en latas, considero estas tapas súper útiles. Caben en algunas latas de tamaño pequeño y mediano, porque en las grandes, no todas. No sellan por completo, pero sí son un "salvavidas" en caso de tirar la lata, pues solo se derramarán unas cuantas gotas a comparación de un charco de líquido. Considera comprarlas si también consumes mucho dichas bebidas y quieres llevarlas un poco más contigo sin temer a derramar su contenido. R E C O M E N D A D A S

We got this for my son. Easy to put on a soda can and spill proof. My son loves it and he doesn’t drink a whole can so it’s nice we can close it and out back in the fridge.

They do work as described, so they get 5 stars.